You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.
To avoid clogs, pay attention to what you flush. Sanitary napkins, thick toilet paper and baby wipes should never be flushed. These items can expand and cause a clog, or get caught on a pipe. Instead, dispose of them in a sanitary way that does not involve flushing them down the toilet.
Don't pay a plumber until the job is completed. A plumber may require some money upfront, but it's wise to wait until the job is completely done before giving him the entire payment. Many things can happen between the stop and end of a job, so to be safe wait until you are satisfied with the completed work before paying.
If your sink is letting rusty water out and it will not drain, it is mostly likely because of the biological scum and grease that is built up in the pipes. You need to have your drains professionally cleaned, allowing maximum flow through your drains. Your drains must be open completely.
Do special checks on your sink overflow holes to ensure they are not becoming clogged. Overflow holes are one of those things which you forget about until you need them. The overflow holes should be cleaned out regularly; do this when you are making your regular checks for other issues that necessitate fixing.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
Hopefully, now that you've read the above tips, the fine art of plumbing is a little less scary to you. Remember what you've learned here, so that you can put in practice when you need to. Also, remember that when all else fails, a plumber is just a speed dial number away.
No comments:
Post a Comment